Guide · Climb simulator

Climb calculator and climb simulator: how they work

You want to know whether you will make it to the top, how long it takes and whether your gearing is easy enough. The climb simulator calculates that for ten famous climbs, kilometre by kilometre. On this page you read how to use it best, what the free and paid versions do, how the model works and which sources it rests on.

Last updated: 2 November 2026

What the simulator does

You pick a climb, enter your FTP and body weight and say how well your bike fits. The simulator calculates per kilometre how fast you go, which gear you choose and at what cadence you pedal. That gives your climbing time, with an honest range.

Press Simulate and you ride the climb at 3 seconds per kilometre. The profile colours along: green is easy, red is hard. A kilometre where your cadence drops below 60 rpm turns bright red and hatched. With this gearing, that part is not really rideable.

The calculator is the engine, the simulator shows what that means on the road. Your climbing time tells you how long it takes; the colours and cadence tell you where it hurts and whether your gearing should change.

How to get the most out of it

  1. 1Use a recent FTPFTP drives most of the uncertainty. A 5 % error in your FTP changes your Ventoux time by about 7 minutes. A test from the last 6 weeks is most reliable. No FTP? Start at 3.0 W/kg and compare with a real test later.
  2. 2Enter your weight honestlyWeight is a calculation value, not a target. Clothing, shoes and bottles are added separately. To see what weight does, change it at the same FTP and look at the difference.
  3. 3Choose your fit deliberatelyPoor means: saddle clearly too high or pain on rides longer than 2 hours. Fair: no fit or an old one, occasional discomfort. Good: your bike was set up recently and you ride without complaints. A good fit gives 1 to 3 % more power on a climb.
  4. 4Look at the red kilometresIf your cadence drops below 60 rpm, the climb becomes hard on your knees and muscles and the pace is difficult to hold. Compare your own bike with the 46/33 + 10-36 climbing gearing and see how many red kilometres disappear.
  5. 5Ride the simulation once all the wayThat shows where the climb gets steeper and where you need to shift. Then use the per-km table as a cheat sheet on the road.
  6. 6Use your leversIn the paid tier you see what 5 % more FTP, 2 kg less, a better fit, faster tyres, days at altitude and a lower position bring. That shows which change helps you most, and which works right away without weeks of training.

Free, with an account or paid

The simulator is free to use. With a free account you calculate with your own data. A single fit or annual plan gives you the complete preparation.

Free, no accountFree accountSingle fit or annual plan
Climbing time and simulationYesYesYes
Range±11 %±7 % with your FTP±7 % with your FTP
FTP and weightYour own inputFrom your dashboardFrom your dashboard
Bike and gearingStandard compactYour own bikeAll your bikes and climbing gearing
Per-km table3 km3 kmEvery km
Preparation advice–6 parts10 parts
Altitude and days at altitude––Yes
Food and drink––Yes
Your levers––Yes
TipsIn Dutch onlyIn Dutch onlyIn Dutch only

A single fit costs €13.50, an annual plan €21.50. Both give access to the complete advice.

Using it for free

Without an account you calculate with a standard compact (50/34 + 11-32) and a bike of 8.5 kg. That is enough to see whether a climb is within reach and roughly how long you will be on it. The range is wider, because we know nothing about you.

With a free account

The simulator uses the FTP, weight and bikes from your dashboard. If you did a bike fit, you see that in the fit choice. Your settings are saved, the range gets narrower and you get the first six parts of your preparation advice.

With a single fit or annual plan

You see every kilometre with speed, gear, cadence, power, torque and split time. You calculate with all your bikes, see what days at altitude do, get a food and drink plan for your climbing time and a list of levers sorted by time gained.

How the model works

The model uses the standard physics of cycling power: gravity on the gradient, rolling resistance (Crr 0.005) and air resistance (CdA 0.40), with air density that decreases with altitude. Uphill, gravity is by far the largest factor; aerodynamics matter little.

How much of your FTP you can hold depends on how long the climb takes. You ride a 10 to 15 minute climb above your FTP, a half-hour climb at about 90 % and a two-hour climb well below it. The model finds the climbing time and power that match.

At altitude your power drops because there is less oxygen. The model uses the regressions by Bassett and colleagues, and an acclimatisation curve when you spend days at altitude. With days at altitude it also includes the growth of your haemoglobin.

Per kilometre the model picks the gear that brings your cadence closest to 80 rpm. If the cadence in your easiest gear drops below 60 rpm, we mark that kilometre as not rideable with this gearing.

Your fit counts as a small factor on your power: −4 % for poor, −2 % for fair and 0 % for good. If your FTP was measured on the same bike in the same position, your fit is already included. In that case choose Good.

Energy use is calculated from the work done with a gross efficiency of 22 %. Carbohydrate per hour follows the duration of the climb; drinking aims at less than 2 % body weight loss.

How reliable is the result?

A simulation is an estimate. That is why we always show a range: the time you will probably finish within. Without your own data that is about ±11 %, with the FTP from your dashboard about ±7 %.

The largest sources of uncertainty are your FTP, how much of it you can hold for the duration of the climb, and the altitude effect. Rolling resistance, bike weight and aerodynamics matter much less.

Not every number is equally solid. Physics and geometry are certain. The effect of altitude and acclimatisation comes from studies in trained athletes. The effect of a bike fit and the share of your FTP you can hold are rules of thumb; we always show them with a range.

Evidence level per part

Power from speed, gradient and massAPhysics
Air density at altitudeAStandard atmosphere
Cadence, gear and torqueAGeometry
Share of FTP you can holdCCoaching rule of thumb and power-duration models
Power loss at altitudeBBassett 1999; Wehrlin & Hallén 2006
AcclimatisationBSchuler 2007
Haemoglobin gain during a stayA/BGore 2013 and later studies
Effect of your bike fitCSmall lab studies on saddle height
Energy and carbohydrateAJeukendrup 2014; ACSM

A: solid. B: number with a range. C: estimate, improve it with your own data.

What bike fitting has to do with climbing

A good fit gives 1 to 3 % more power on a climb compared with a fair one, and up to 5 % if your saddle is clearly too high. On the Ventoux that is a few minutes for an average rider, about the same as being 2 kg lighter.

The biggest gain is less pain and discomfort. If you want to pedal steadily for two hours, a good position helps more than a stiffer frame. Research shows no measurable effect of frame stiffness when climbing seated.

A fit is also a direct lever: you do not need weeks of training for it. Together with your gearing it is the quickest way to make a climb easier.

Start a free bike fit

Medically careful

The simulator does not give medical advice. Weight is a calculation value, not a target weight. Do not drink more than you sweat. If you have pain or complaints, see a fitter, physiotherapist or doctor.

Every body reacts differently to altitude and heat. Build up your effort, listen to your body and check road status and weather beforehand.

Frequently asked questions

Why is my time a range and not an exact number?

Because your FTP, your form on the day, the weather and the altitude are all uncertain. The range shows where you will probably finish. With your own dashboard data it gets narrower.

What does a bright red kilometre mean?

That your cadence drops below 60 rpm there in your easiest gear. You may still make it, but it takes a lot of force per pedal stroke. An easier gear makes that part more rideable.

Does the simulator include my bike fit?

Yes, as a small factor on your power. With an account you see whether you have a bike fit in your dashboard. If your FTP was measured on the same bike in the same position, choose Good.

Which climbs can I choose?

Alpe d'Huez, Mont Ventoux (Bédoin), Col du Tourmalet, Col du Galibier, Passo dello Stelvio, Sa Calobra, Col d'Izoard, Passo del Mortirolo, Monte Zoncolan and Alto de l'Angliru.

Do I have to pay to use the simulator?

No. Climbing time, simulation and colours are free. A free account adds your own data and bike. A single fit or annual plan gives you the complete preparation.

Sources

The model is built from published research and public climb data. Where research is missing, we use a rule of thumb and show a range.